Door Hinge Drilling Guide

Hinge hole positions must be entered based on your own measurements.
When selecting Drilling Required, please enter the hinge positions according to your measurements.
All hinge measurements should be entered to the centre of the 35mm hinge cup hole.
Please check your cabinet dimensions and hinge requirements carefully before placing your order.

Hinge cup with two pilot holes for screws. Recommended for most DIY and one-off installation situations.

Door handing is determined by looking at the front of the door.

Most concealed door hinges for face frame cabinets require a 3 mm bore distance.

This distance is measured from the edge of the door to the edge of the 35 mm hinge cup hole.

The standard bore offset is 100 mm.

This distance is measured from the top or bottom edge of the door to the centre of the 35mm hinge cup hole.

Door Type	Drilling	Notes
Drawer Frontals	Not drilled	Drawer frontals do not require hinge holes
Saucepan Drawer Fronts	Not drilled	Large drawer fronts are not hinge drilled
Dishwasher Doors	Not drilled	Appliance doors are not drilled for hinges
Integrated Washing Machine Doors	Drill on site	Drilling depends on appliance installation
Built-in Handle Doors	Special drilling required	Different hinge drilling pattern
Lazy Susan Doors	Special drilling required	Requires a different hinge drilling layout
Magic Corner Systems	Not drilled	Hinges depend on the corner mechanism
Bin System Doors	Not drilled	Door drilling varies by bin system

2 Hinges
Up to 914 mm

3 Hinges
915 mm – 1828 mm

4 Hinges
1829 mm – 2743 mm